|
CAP Ebb&Gro Controller Module
- Controls the fill drain cycles which controls the feeding schedule to the Ebb & Gro grow pots
- Set the desired feeding schedule on the controllers built-in timer
- Normal Operation; set the timer to fill and drain the pots about 3 or 4 times a day
- When the fill and drain cycle that you set comes on, it turns on the pump in the large reservoir (the 55 gallon drum), and starts filling the controller unit.
- Since the grow pots are all plumbed to the controller unit, the water in the entire system starts to level off with the controller unit
- Since the grow pots are all plumbed to the controller unit, the water in the entire system starts to level off with the controller unit
- When the pots are full, and your drain cycle starts, the pump in the controller unit pumps all of the water back into the reservoir
- When the level of the water in the controller unit goes down, all of the grow pots levels go down also; then the controller unit waits for the next fill and drain cycle a few hours later
- Build your own system
|
